Tasel

TDA7294, monolithic IC with output up to 100W as main core for this useful audio amplifier. This circuit is a mono for a single channel in 4Ω or 8Ω load. Simple audio class A-B amplifier.

Based on three characteristics: good quality sound, easy to make, and not expensive circuit, this TOSHIBA DX is worth to try. Just need 36VDC voltage input as a fuel, the circuit can produce 100W output on 40 Ohm speaker or 50W on 80 Ohm, using a pair of TOSHIBA A1943 – C5200 per channel.

The circuit using active component to operating. In this case, the active component is IC NE5532 or TL072 as a linear part. With 15 V power supply, this circuit separate the low out and high out. The low out connected to a woofer, and high out in tweeter.

Mini stereo audio amplifier with low distortion. Take about 10% distortion on 4 Ohm – 8 Ohm loudspeaker. The LM4756 can delivers 7W power output. This small audio amplifier also featured quiet fade-in/out mute function, stereo variable line-out pins, AC output short circuit protection, and thermal shutdown protection.

This 400 W MOSFET Audio Amplifier using IRFP448 circuit is simple project. With low noise and distortion, but powerful. As the fuel, this project consume 70-80 Vdc and 5 A fuse as the protector for short circuit.

This circuit ease you to control any appliance with infra red remote. Can be used for electrical devices like lamp, fan, etc. With power supply from itself, the circuit make the application compact and easy to control. The circuit looks for any modulated IR source and uses it to control a TRIAC, which then switches [...]

IC Op-amp 741 as main chip for Infra Red receiver and transmitter. Infra Red LED connected with SCR trigger by pulse which produced from this Op-amp 741 when the SW in close position.

Can be a standalone or teamed with Pre-Amp, this circuit show us a high-class headphone amplifier. With low distortion and noise, its seat drive low or high impedance to max power levels. Need only a power supply and a volume control pot for apply among any line-level signal source, and featured dual output.

Based on super hetero dyning principle. The circuit using 2 RF oscillators. The frequencies of all oscillators are at 5.5 MHz. The first RF oscillator consist of transistor T1 (BF 494) and a 5.5MHz ceramic filter. The 2nd oscillator is a Colpitt’s oscillator accomplished with the help of T3 (BF494) and inductor L1 shunted by [...]