Electronics Schematic Diagram
This 400 W MOSFET Audio Amplifier using IRFP448 circuit is simple project. With low noise and distortion, but powerful. As the fuel, this project consume 70-80 Vdc and 5 A fuse as the protector for short circuit.
Here is a portable headphone amplifier for your music player. This circuit improve the gadget audio outputs with low noise and distortion, as well as a long battery life. With an external amplifier, the headphone driver in the music player is no longer required to supply high currents into a low impedance.
Conventional power amplifier with high-pass and low-pass filter. Supplied 60V DC, this circuit can produce about 300W sound power. Opamp NE5534 is arranged as a differential amplifier, output of NE5534 is applied to drive stages MJE340 and MJE350 via R6 from pin 6. The output amplifier proper consists of drive stages MJE1530 and MJE1531 and [...]
IC Op-amp 741 as main chip for Infra Red receiver and transmitter. Infra Red LED connected with SCR trigger by pulse which produced from this Op-amp 741 when the SW in close position.
High-performance amplifier. Ultra low distortion but high voltage DC while operated. Using two on-board 6.5A fuses, just cause this circuit is capable of delivering around 300W of music power into 4Ω, each fuse carries around 4.4A RMS or higher.
Using IC 4001, 4027, NE555, and CA3130, this circuit can convert 24VDC to 220VAC 300W. A pairs of MJ15003 or 2N3773 as the last active components before drive the pulse into the transformator.
Here is the VU meter with 12 LEDs circuit. This is an easy visual indicator of the audio level signals. Can be applied to various input levels, adjusted by trimmer TR1 (state) – TR2 (Gain), then rectified by diodes D1-D2 (standard negative mark-recovery periods) and provide in the main circuit indication, consisting of the diodes [...]
Based on super hetero dyning principle. The circuit using 2 RF oscillators. The frequencies of all oscillators are at 5.5 MHz. The first RF oscillator consist of transistor T1 (BF 494) and a 5.5MHz ceramic filter. The 2nd oscillator is a Colpitt’s oscillator accomplished with the help of T3 (BF494) and inductor L1 shunted by [...]