Tasel

This inverter circuit is very useful for low load application such as emergency light, radio, or DVD player. With transistors as main active component, please take more attention when you assemble this 100 W inverter circuit. Power source of this circuit just 12V DC, but can produce about 100W at 220V AC with simple assembling [...]

The circuit using active component to operating. In this case, the active component is IC NE5532 or TL072 as a linear part. With 15 V power supply, this circuit separate the low out and high out. The low out connected to a woofer, and high out in tweeter.

This is a small and simple audio amplifier with TDA7294. Using 2 TDA7294 for stereo (2×80 watt) mode and bridge mode (180 watt). The TDA7294 for use as class AB audio amplifier.

Can be a standalone or teamed with Pre-Amp, this circuit show us a high-class headphone amplifier. With low distortion and noise, its seat drive low or high impedance to max power levels. Need only a power supply and a volume control pot for apply among any line-level signal source, and featured dual output.

Conventional power amplifier with high-pass and low-pass filter. Supplied 60V DC, this circuit can produce about 300W sound power. Opamp NE5534 is arranged as a differential amplifier, output of NE5534 is applied to drive stages MJE340 and MJE350 via R6 from pin 6. The output amplifier proper consists of drive stages MJE1530 and MJE1531 and [...]

For large source supply at your amplifier or another application, this DC-DC converter is recommended. This circuit already tested, and no problem when connected the load.

High-performance amplifier. Ultra low distortion but high voltage DC while operated. Using two on-board 6.5A fuses, just cause this circuit is capable of delivering around 300W of music power into 4Ω, each fuse carries around 4.4A RMS or higher.

IC Op-amp 741 as main chip for Infra Red receiver and transmitter. Infra Red LED connected with SCR trigger by pulse which produced from this Op-amp 741 when the SW in close position.